![]() ![]() With the Remover tool, you can either click to remove individual lights, or draw a rectangle around an area to remove all lights within the space. Click to recover any lights that have been removed with the Remover tool. A small green input box appears in the upper left corner where you can choose to reset the selected ceiling (Single) or all ceilings in the drawing.(All). Select the Reset tool and hover the mouse pointer over a ceiling. In the Ceiling section, there is also a tool to reset the light, and a remover tool: If you are using Multiple suns you do not need to make the ceiling solid: If you are using Natural or Simple lighting in combination with the ceiling grid, be sure to check the Solid check box so the space isn’t over lit. In the green properties box that is displayed when the ceiling is selected, you can make settings for your ceiling.Move the mouse pointer outside of the drawing area or hit the Esc key to release the ceiling component.Move the mouse down to the desired depth, or enter a measurement in the green input box.Start moving the mouse sideways to the desired width, or enter a measurement in the green input box.Pick the desired ceiling component and move the mouse pointer to the drawing area.To place one of these ceilings, follow these steps: Place either a Florescent ceiling or a Light wire grid which have integrated lights. ![]()
0 Comments
Leave a Reply. |